Re-bending sides...

[Taffy Evans]

Hi, the other week I pulled a set of sides off the shelf that I had bent up, 000 size, about a year ago ready to start a new build. Whilst preparing for this new build I noticed that both sides were the same bend, not a bass and treble side set. Oops, I wonder who did that?

The photos show how I got around the problem. I flattened the faulty side out and re-bent it, and it worked fine.
Photos should tell the story.

01-IMG_0106.JPG (138.92 KiB) Viewed 29214 times

03-IMG_0109.JPG (128.74 KiB) Viewed 29214 times

04-IMG_0110.JPG (120.15 KiB) Viewed 29214 times

05-IMG_0111.JPG (141.61 KiB) Viewed 29214 times

06-IMG_0112.JPG (148.55 KiB) Viewed 29214 times

09-IMG_0115.JPG (120.4 KiB) Viewed 29214 times

10-IMG_0116.JPG (118.88 KiB) Viewed 29214 times

11-IMG_0117.JPG (136.9 KiB) Viewed 29214 times

12-IMG_0118.JPG (150.58 KiB) Viewed 29214 times

I lost a couple of photos, but you get the idea.
Taff

[Dave M]

Reckon you were lucky to get away with that Taffy. I'm sure if I tried that I would have cracks all over the place! What is the timber.

[kiwigeo]

Nice save Taff.

[Taffy Evans]

Hi Dave, the back and sides are New Guinee Rosewood. Martin, I may have been lucky due to the fact the sides were prepped a bit too thin. In fact, I ended up making them a laminated set with stiffer side braces and kerfing. OOO size.

3-IMG_0196.JPG (133.13 KiB) Viewed 28936 times

2-IMG_0198.JPG (131.23 KiB) Viewed 28936 times

Taff