Hello All
This guitar turned up at our Saturday swarm. The guy that owns it got it from the local dump and has had it nicely restored. Anybody know anything of these guitars and their history in Oz? We have searched inside and cannot find any info other than what is on the patch.
The patch says made in America and distributed in Sydney ... sorry the photo is not clearer. Looks like some sort of American oak ....
Cheers Pete
Recognise this one?
- Peter Young
- Myrtle
- Posts: 55
- Joined: Mon Jun 23, 2008 3:27 pm
- Location: Albany Western Australia
- Contact:
Recognise this one?
In pursuit of the lies & lore of lutherie
- graham mcdonald
- Blackwood
- Posts: 473
- Joined: Thu Oct 25, 2007 11:57 am
- Location: Canberra
- Contact:
Re: Recognise this one?
Probably made in Chicago between the turn of the century and the 30s by Lyon & Healy, Regal or Harmony, and imported by Alberts who have been round for 120 years.
Graham McDonald
http://www.mcdonaldstrings.com
http://www.mcdonaldstrings.com
- DarwinStrings
- Blackwood
- Posts: 1873
- Joined: Thu Nov 13, 2008 10:27 pm
- Location: Darwin
Re: Recognise this one?
Could I get better look at the fret board inlay please Pete, it looks like Oscar Schmidt from this angle. Graham may be right too it could be Lyon and Healy(washburn) or maybe Stromberg Voisinet. Seems there were heaps of Chicago makers making un-labelled guitars for sale by distributors.
Jim
Jim
Life is good when you are amongst the wood.
Jim Schofield
Jim Schofield
- Peter Young
- Myrtle
- Posts: 55
- Joined: Mon Jun 23, 2008 3:27 pm
- Location: Albany Western Australia
- Contact:
Re: Recognise this one?
Thanks for your interest and information
Not sure if this is the original neck .... the bridge was a re make.
Hope this helps out.
Regards Peter
Not sure if this is the original neck .... the bridge was a re make.
Hope this helps out.
Regards Peter
In pursuit of the lies & lore of lutherie
- DarwinStrings
- Blackwood
- Posts: 1873
- Joined: Thu Nov 13, 2008 10:27 pm
- Location: Darwin
Re: Recognise this one?
Yep, that helps those are typical high end "Stella" or "Sovereign" Oscar Schmidt fret board inlay. Most likely made in the 20's in New Jersey. Low end ones had birch tops as well as back and sides and higher end had spruce tops, your looks like it is somewhere in between low and high with its high end inlay and low end top wood.
Jim
Jim
Life is good when you are amongst the wood.
Jim Schofield
Jim Schofield
- DarwinStrings
- Blackwood
- Posts: 1873
- Joined: Thu Nov 13, 2008 10:27 pm
- Location: Darwin
Re: Recognise this one?
One of my mates has the spruce topped job labelled "Sovereign" you can hear him playing slide on it HERE
Jim
Jim
Life is good when you are amongst the wood.
Jim Schofield
Jim Schofield
Who is online
Users browsing this forum: No registered users and 47 guests