Australian/New Zealand Luthiers Forum

So this is another one of the the Jigs I made so I could radius the fret-boards and do compounds as well has some adjustment screws at either side once you set it flat on the bed,It worked OK as you are really taking just a lick off the edges .
One of the things you do I suppose is a blank electric neck with fret board attached and then shape later I never got that far just did a couple of fret boards with a you bute double sided tape and then a thin blade to peel it off Seeing as I had the sander and some scrap metal I thought I would give it a go ( in the midst of res-erecting all the old jigs I made) all good fun ,John.

Nice build, Looks very similiar to the grizzly supplied units

Steve

Yes there is not too many ways to geta radius this jig was from scrap about the workshop. I took a look a few years ago there were many some wooden set ups and the like because I have the engineering gear already I decided to put one together ,I also liked the neck shaping jigs these guys on the net make but I get side tracked easy .