I've been busy in the shed doing the thing I like best ..Inventing things ..This one is an idea I thought up sometime back but never got round to building it to see if it worked....After i've cut the dovetails on the router and then bandsaw..there is always a bit of hand work to do to get a good fit.... So this device is to remove the final bits of wood at the end of the heel that I usually do with the chisel.
It turned out to work so well that i'm going make a better one using proper engineering materials instead of the scrap box parts..maybe I could add a motor
Anyway here is a video I made of the device.
http://www.youtube.com/watch?v=rA7o-8Osz0Q
Another Jig tool thingy video
Re: Another Jig tool thingy video
That's a good one Ken.
- Nick
- Blackwood
- Posts: 3642
- Joined: Thu Feb 26, 2009 11:20 am
- Location: Christchurch, New Zealand
- Contact:
Re: Another Jig tool thingy video
I'd be adding a motor Ken, after twenty odd necks you could be getting sick of it, mind you I'd be getting sick of it after two! I HATE repetitive tasks.
"Jesus Loves You."
Nice to hear in church but not in a Mexican prison.
Nice to hear in church but not in a Mexican prison.
- Mark McLean
- Blackwood
- Posts: 1087
- Joined: Thu Apr 10, 2008 2:03 pm
- Location: Sydney
Re: Another Jig tool thingy video
Makes me feel better about the total mess in my workshop - must be because my brain has been working!
Nice jig Ken.
Mark
Nice jig Ken.
Mark
- Bob Connor
- Admin
- Posts: 3132
- Joined: Mon Jul 09, 2007 9:43 pm
- Location: Geelong, Australia
- Contact:
Re: Another Jig tool thingy video
Nice thinking Ken.
Regards
Regards
Re: Another Jig tool thingy video
Well I made a better designed sanding thingy, it only took a couple of hours..I made it more simple this time the dovetail block is made from Delrin mounted on a couple of 7mm bright steel rods ..I can now add this to my jig collection BTW I scrapped the prototype.
Here are a couple of pic's in case someone wants to make one in the future.
Here are a couple of pic's in case someone wants to make one in the future.
Who is online
Users browsing this forum: No registered users and 58 guests