Australian/New Zealand Luthiers Forum

Just ordered me one of these babies from Carbatec - http://www.rockler.com/trim-router-table.
I only have two uses for a router table at the moment: rounding the edges of my solid linings, and classical bridges.

Figured this simple tool would cover everything I needed for now.

Will post some pics and feedback next week, but in the meantime, has anyone used one of these?

Wayde Christie wrote:, but in the meantime, has anyone used one of these?

No, I just go with my low-tech router table. I simply clamp a wooden fence to the edges of the table when needed.



I don't use it often, so the hight adjustment mechanism is still waiting to be made. Not in the picture: I use a foot operated dead man's switch to run this table router (I even use one for my drill press).

Wayde, take Christian's jig, fixture and tool making talents with a huge grain of salt, you know like the ones they give cows. He can turn scraps into a saw the rivals a $1,400 production saw. He made is own version of aJointmaker Pro. Why? Because he could. That and shipping was a bear to his hilltop home.

Hi Wayde, here's mine comes complete with the router, I don't use it much but its there if I need it. Height adjustment is a pain.