I'm wondering if anybody has used Crystalac Brite Tone for their acoustic instruments? How does it perform? Does it damp the sound? Can it be applied in small ares over old Crystalac for finish repairs?
Cheers! Ross
Crystalac
-
blackalex1952
- Blackwood
- Posts: 776
- Joined: Tue Aug 27, 2013 6:36 pm
- Location: North East Victoria
Crystalac
"Everything I say on the topic is based solely upon inexperience and assumption!"
-
Steve.Toscano
- Blackwood
- Posts: 495
- Joined: Thu Feb 07, 2013 11:43 pm
- Location: Port Stephens NSW
Re: Crystalac
Ive used it on electrics.
It applies (with a brush) quite well and somewhat self levels. Still requires a rub back and a buff of course to get to a high gloss.
No where near as hard wearing as nitro or a poly.
I wouldn't use it on acoustic instruments as its high solids.
Not sure about applying over itself, if you read the hype apparently it does this well, but i've never tryed it.
It applies (with a brush) quite well and somewhat self levels. Still requires a rub back and a buff of course to get to a high gloss.
No where near as hard wearing as nitro or a poly.
I wouldn't use it on acoustic instruments as its high solids.
Not sure about applying over itself, if you read the hype apparently it does this well, but i've never tryed it.
-
blackalex1952
- Blackwood
- Posts: 776
- Joined: Tue Aug 27, 2013 6:36 pm
- Location: North East Victoria
Re: Crystalac
Thanks Steve..I have a finish repair to do...Cheers! Ross
"Everything I say on the topic is based solely upon inexperience and assumption!"
Who is online
Users browsing this forum: No registered users and 69 guests