It would make them stiffer and I could draw on them.
Then I wondered if I could use my laminator as a heat source alongside a dowel jig as a side bending setup.
Since the thermostat packed in it seems to gt hot enough.
A4 laminated templates or laminator/ side bender?
A4 laminated templates or laminator/ side bender?
I was just about to glue my copies of my plans to cardboard to make templates when I wondered of it would be better to use my A4 laminator.
It would make them stiffer and I could draw on them.
Then I wondered if I could use my laminator as a heat source alongside a dowel jig as a side bending setup.
Since the thermostat packed in it seems to gt hot enough.
It would make them stiffer and I could draw on them.
Then I wondered if I could use my laminator as a heat source alongside a dowel jig as a side bending setup.
Since the thermostat packed in it seems to gt hot enough.
Martyn
The glass is half full... but I'll have another while your up!
It's not over until Ricky Pontin cries! (Not long now).
Great minds like a think!
The glass is half full... but I'll have another while your up!
It's not over until Ricky Pontin cries! (Not long now).
Great minds like a think!
Who is online
Users browsing this forum: No registered users and 166 guests