Should I try to get the grain closer to vertical through the 1/4" thickness rather than horizontal or doesn't it matter?
Does it matter how grain is aligned in rosewood fingerboards
Does it matter how grain is aligned in rosewood fingerboards
Does it matter how the grain is aligned in Australian rosewood fingerboards ? I have a 2"+ thick slab that I plan to cut a 2" wide length off for fingerboards. The grain will be diagonal however I slice it.
Should I try to get the grain closer to vertical through the 1/4" thickness rather than horizontal or doesn't it matter?
Should I try to get the grain closer to vertical through the 1/4" thickness rather than horizontal or doesn't it matter?
Martyn
The glass is half full... but I'll have another while your up!
It's not over until Ricky Pontin cries! (Not long now).
Great minds like a think!
The glass is half full... but I'll have another while your up!
It's not over until Ricky Pontin cries! (Not long now).
Great minds like a think!
Who is online
Users browsing this forum: No registered users and 52 guests